ESD Access Control

1.Comprehensive test mode and single test mode.Can be tested at the same time or separately test the wrist band and foot ring, conductive shoes, anti-static shoes .And you can choose single or double wrist wristbands test.

2.With access control system control signal: the tester can output a signal to control the access control system, control personnel to enter and exit the place to prevent static electricity.

3.By using the micro current test, the test is more stable, the test data is more accurate. When the battery is low, the red light of the low power (REPLACE BATTERY) alarm

4.When the test result is lower than the value of the lower, the low status indicator light is on the test instrument panel. Higher than the value of high-grade, high status indicator light. Test results in the low and high value between the value, the qualified status indicator light.

5.When needed to test the content of all qualified, will be output through the switch signal, while output one way of open signal .When any one of the options test is not qualified, there will be closed signal output. When fully qualified, close signal will be off.
The opening and closing signals are respectively output by different interfaces.

6.The output of switching signal using KAQW214 optical relay, conduction current maximum: ±100mA,maximum voltage: ± 400V.

7.RS232 or RS485 means of communication can be used to send the test results and determine the state to the host. Test the default mode of use of RS232 communication.